Licenses: PA: #PA052821 | NJ: #13VH12184700 | MD: #163710 | DE: #2021712948Fully Bonded & Insured · Serving PA, NJ & MD
Home / Locations / Longport, NJ / Roof Installation

New Roof Systems for Longport Builds and Raised Homes

New construction in Longport is rarely a simple gable. Houses get rebuilt taller and raised on pilings, third floors gain roof decks, and additions have to tie into framing someone else laid out decades ago a few feet from the property line. Every one of those transitions is a place where wind-driven rain will look for a way in, and almost all of them get covered by finish work within a day or two of being installed.

This is roof installation as our Longport, NJ office does it — the same crew, the same number, the same written estimate before anything starts.

An installation covers the full assembly, from sheathing through ridge, and it gets specified for the site before the first bundle is lifted. On a new build near the bay the deck goes down first, then perimeter metal, then protection at the eaves and valleys, then underlayment, and only afterwards the starter, field and caps, each in the sequence the manufacturer specification demands, with intake and exhaust ventilation sized as a matched pair. Where a plan puts a roof deck or a low-slope section above living space, membrane goes down as a designed system with its own terminations rather than as filler between two pitched planes.

Terminations are where coastal roofs are won or lost. A kickout flashing at the base of a wall-to-roof junction is small, cheap and routinely left off, and its absence turns every rainfall into a slow soaking of the wall cavity, which on a salt-air exposure attacks fasteners and framing at the same time. Headwall and sidewall flashing gets lapped so water leaving the roof cannot be driven back up underneath it. Fasteners are corrosion resistant throughout, including the ones nobody will ever see again. Shingle and panel layout is set so perimeter courses land where the enhanced fastening pattern can actually be used.

Whoever is holding the project, builder, architect or owner, sees the same paperwork. The consultation costs nothing, the estimate is itemized, and the proposal states in writing exactly which flashing details are covered, alongside a dry-in date the trades behind us can plan against. At the end there is a walkthrough, a magnet sweep and warranty documents in hand. Call the office at (640) 500-2297 early if a roof deck is part of the design. We push back on splitting roof and deck waterproofing between two trades, and we will not install over decking we have not been allowed to inspect.

Why Longport roofs are different

Building on the southern end of the island means designing for a wind field that never fully settles. A house raised on pilings stands above its neighbors and loses whatever shelter the block used to give it, and a lot near the inlet catches wind off open water from two directions inside the same storm. We spec ventilation, fastening and flashing for the actual parcel, whether it sits in Longport, across toward Somers Point, or down the coast in Ocean City where the exposure changes again.

  • All Pro Timber Crown Roofing
  • Address: 202 N Colgate Ave, Longport, NJ 08403
  • Phone: (640) 500-2297
  • Hours: Open 24 hours, seven days a week
  • Licensed & insured in New Jersey#13VH12184700
  • Serving: Longport and Atlantic County

View the Longport listing on Google Maps

Other roofing work we do in Longport

Roof Repair in Longport · Roof Replacement in Longport

Roof Installation in nearby markets

Roof Installation in Mt Laurel Township · Roof Installation in Vineland · Roof Installation in Williamstown · Roof Installation in Hampton

Read the full roof installation service page for the technical detail that applies everywhere we work, or see everything we cover across Atlantic County.

Towns our Longport office covers

Ocean City, NJ

Roof Installation in Longport

Reviews from Google

What Longport customers say5.0★ from 16 Google reviews

★★★★★

They were easy to work with and kept us updated throughout the project. The finished roof looks fantastic.

William Baker, on Google
★★★★★

Very pleased with the new roof. The roofing contractor did a thorough job and made sure everything was installed properly.

Jenifa Johson, on Google
★★★★★

The entire process was simple and stress-free. The new roof looks great, and the workmanship is excellent.

Louis Marsh, on Google

Roof Installation in Longport — common questions

Do you work with builders on projects across the island?

Yes. Ground-up houses, third-floor additions and gut renovations are all regular work in Longport and the neighboring shore towns. Give us the roof plan and the pitches, and we will hold your dry-in date and stay clear of the trades on either side of us. The proposal names every flashing and ventilation detail carried in the price, so none of it has to be relitigated when the punch list appears.

Can a roof deck sit over living space without leaking?

It can, if it is designed as a waterproofing assembly with a walking surface on top rather than as a deck that happens to be over a room. That means membrane with proper slope to drains or scuppers, terminations carried up behind the wall finish, and pedestals or sleepers that puncture nothing. Getting the roofer and the deck builder into the same conversation before framing is the whole trick.

What roofing materials suit a new house in Longport?

Architectural or designer asphalt shingles with a wind rating matched to the exposure, standing-seam or exposed-fastener metal in coastal-appropriate coatings, and TPO, EPDM or modified bitumen on any flat or low-slope area. Cool-roof options are worth discussing where a large plane faces the afternoon sun. What matters more than the choice is that every fastener and every piece of flashing is specified for salt exposure.

How is a new addition joined to the roof that is already there?

Never by shingling across the junction. We strip back to solid sheathing on the old plane, build the new one up to meet it, then treat the joint as its own detail with membrane beneath, step or valley metal through it, and a kickout wherever it terminates against a wall. Exposure is matched on both sides so the line disappears. Out here the added requirement is corrosion-resistant metal at that joint, since it gets soaked repeatedly.

What licensing and insurance covers a New Jersey project?

Yes. The company holds NJ #13VH12184700 for New Jersey work, plus PA #PA052821, MD #163710 and DE #2021712948, and is bonded and insured. On a Longport project that usually matters twice: once when the permit is issued and again when a lender or general contractor wants insurance documentation before the first delivery. Ask early and we will get that paperwork moving alongside the design.

Roof Installation in Longport? Call (640) 500-2297.

Free, no-obligation estimates. Licensed & insured in PA, NJ, MD & DE.

Call (856) 292-7046Request a Free Estimate